2011-2013 Land Cruiser · Service Manual Vehicle Exterior

REASSEMBLY

Removal / installation · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


1. INSTALL NO. 2 REAR BUMPER SIDE BRACKET (w/ Tire Carrier)

B185559E01
  1. Attach the 3 claws and 2 clips to install the No. 2 and No. 3 brackets.

  1. Install the 2 screws.


2. INSTALL REAR FOG LIGHT ASSEMBLY LH

B181016
  1. Attach the claw to install the fog light.

  1. Install the 2 nuts.


3. INSTALL REAR FOG LIGHT ASSEMBLY RH

HINT:
Use the same procedures described for the LH side.


4. INSTALL REAR BUMPER ENERGY ABSORBER

B184218
  1. Attach the 8 claws to install the energy absorber.


5. INSTALL NO. 2 ULTRASONIC SENSOR RETAINER (w/ TOYOTA Parking Assist-sensor System)

E156762E01

HINT:
Use the same procedure to install the No. 2 ultrasonic sensor retainer on the other side.

  1. Align the keyhole and protrusion as shown in the illustration.

  1. Install the ultrasonic sensor retainer to the rear bumper.

    NOTICE:
    Do not damage the bumper with the protrusion when installing the retainer.


6. INSTALL NO. 3 ULTRASONIC SENSOR RETAINER (w/ TOYOTA Parking Assist-sensor System)

E128355E01

HINT:
Use the same procedure to install the No. 3 ultrasonic sensor retainer on the other side.

  1. Attach the claw to install the ultrasonic sensor retainer as shown in the illustration.


7. INSTALL NO. 2 ULTRASONIC SENSOR (w/ TOYOTA Parking Assist-sensor System)

E146466

HINT:
Use the same procedure to install the No. 2 ultrasonic sensor on the other side.

  1. Attach the 2 claws to install the ultrasonic sensor.

  1. Connect the connector.


8. INSTALL NO. 3 ULTRASONIC SENSOR (w/ TOYOTA Parking Assist-sensor System)

E162155

HINT:
Use the same procedure to install the No. 3 ultrasonic sensor on the other side.

  1. Attach the 3 claws to install the ultrasonic sensor.

  1. Connect the connector.


9. INSTALL NO. 2 FRAME WIRE

  1. w/ TOYOTA Parking Assist-sensor System, w/ Rear Fog Light:
    Install the No. 2 frame wire.

    1. Attach the 16 clamps to install the frame wire.

    2. Connect the 6 connectors.

      B184219

  1. w/ TOYOTA Parking Assist-sensor System, w/o Rear Fog Light:
    Install the No. 2 frame wire.

    1. Attach the 14 clamps to install the frame wire.

    2. Connect the 4 connectors.

      B183028

  1. w/o TOYOTA Parking Assist-sensor System, w/ Rear Fog Light:
    Install the No. 2 frame wire.

    1. Attach the 13 clamps to install the frame wire.

    2. Connect the 2 connectors.

      B185557

← DISASSEMBLY (from Jan 2012)REASSEMBLY (from Jan 2012) →