2011-2013 Land Cruiser · Service Manual Vehicle Exterior

DISASSEMBLY

Removal / installation · Vehicles built from Sep 2011

HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.


1. REMOVE NO. 1 SIDE STEP BRACKET LH

B180954
  1. Remove the 2 bolts and side step bracket.


2. REMOVE NO. 2 SIDE STEP BRACKET LH

B180953
  1. Remove the 2 bolts and side step bracket.


3. REMOVE NO. 3 SIDE STEP BRACKET LH

B180952
  1. Remove the 2 bolts and side step bracket.


4. REMOVE REAR STEP PANEL LH
  1. Put a 4 mm (0.157 in.) drill bit into a drill.

  1. B189900E01
    Wind tape around the drill bit approximately 5 mm (0.197 in.) from the tip of the drill, as shown in the illustration.

    HINT:
    Tape the 4 mm (0.157 in.) drill bit to prevent the drill bit from going too deep.

  1. Lightly press the drill against the 2 rivets, drill off the flanges of the 2 rivets, and remove the rear step panel.

    NOTICE:
    1. Pressing the drill too firmly will cause the rivet to turn and result in the rivet not being drilled through.
    2. Do not pry the rivet with the drill, because this may cause damage to the installation holes of the rivet or the drill bit.
    3. Be careful of the drilled rivet as it may become hot.

  1. Using a vacuum cleaner, remove the rivet fragments and shavings from the drilled area.


5. REMOVE FRONT SIDE DOOR STEP PLATE COVER LH

B180956
  1. Remove the 2 screws and side step bracket.


6. REMOVE REAR SIDE DOOR STEP PLATE COVER LH

B180955
  1. Remove the 2 screws and side step bracket.


7. REMOVE NO. 1 SIDE DOOR STEP PLATE MOULDING

  1. Remove the step plate moulding.

    B180951

← REMOVAL (from Sep 2011)REASSEMBLY (from Sep 2011) →