2011-2013 Land Cruiser · Service Manual Vehicle Interior

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


CHECK REAR FLOOR AIRBAG SENSOR (VEHICLE NOT INVOLVED IN COLLISION)
  1. Perform a diagnostic system check (Click here).


CHECK REAR FLOOR AIRBAG SENSOR (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS NOT DEPLOYED)
  1. Perform a diagnostic system check (Click here).

  1. When airbags have deployed as the result of a collision, be certain to replace the rear floor airbag sensor when it is in the damaged area (anywhere in need of repair). Furthermore, it is also necessary to replace the rear floor airbag sensor in an undamaged area that has registered a major collision, or which exhibits any of the following abnormalities:

    1. Cracks, dents or chips on the sensor housing.
    2. Cracks or other damage to the connector.
    3. Peeling off of the label or damage to the serial number.

    CAUTION:
    For removal and installation procedures of the rear floor airbag sensor, be sure to follow the correct procedure.


CHECK REAR FLOOR AIRBAG SENSOR (VEHICLE INVOLVED IN COLLISION AND AIRBAG IS DEPLOYED)
  1. When airbags have deployed as the result of a collision, be certain to replace the rear floor airbag sensor in the damaged area (anywhere in need of repair). Furthermore, it is also necessary to replace the rear floor airbag sensor in a undamaged area that has registered a major collision, or which exhibits any of the following abnormalities:

    1. Cracks, dents or chips on the sensor housing.
    2. Cracks or other damage to the connector.
    3. Peeling off of the label or damage to the serial number.

    CAUTION:
    For removal and installation procedures of the rear floor airbag sensor, be sure to follow the correct procedure.

← ON-VEHICLE INSPECTION (Sep 2011 – Dec 2011)REMOVAL (Sep 2011 – Dec 2011) →