2011-2013 Land Cruiser · Service Manual Vehicle Interior

REMOVAL

Removal / installation · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


2. REMOVE REAR STEP COVER (w/ Sliding Roof)

B181673

HINT:
Use the same procedure to remove the step cover on the other side.

  1. Detach the 2 claws and remove the step cover.


3. REMOVE REAR STEP COVER (w/o Sliding Roof)

B181673

HINT:
Use the same procedure to remove the step cover on the other side.

  1. Detach the 2 claws and remove the step cover.


4. REMOVE REAR DOOR SCUFF PLATE LH (w/ Sliding Roof)

B181674
  1. Remove the screw.

  1. Detach the 3 claws and 4 clips, and remove the scuff plate.


5. REMOVE REAR DOOR SCUFF PLATE LH (w/o Sliding Roof)

B181674
  1. Remove the screw.

  1. Detach the 3 claws and 4 clips, and remove the scuff plate.


6. REMOVE REAR DOOR SCUFF PLATE RH (w/ Sliding Roof)

HINT:
Use the same procedures described for the LH side.


7. REMOVE REAR DOOR SCUFF PLATE RH (w/o Sliding Roof)

HINT:
Use the same procedures described for the LH side.


8. REMOVE REAR FLOOR AIRBAG SENSOR
  1. Fold back the floor carpet.

  1. B181654
    Detach the clip and claw, and remove the cover.

  1. B181655
    Remove the bolt and sensor.

  1. Disconnect the connector.

← ON-VEHICLE INSPECTION (from Jan 2012)REMOVAL (from Jan 2012) →