2011-2013 Land Cruiser · Service Manual Vehicle Exterior

REMOVAL

Removal / installation · Vehicles built from Sep 2011

HINT:
  1. Use the same procedures for the RHD and LHD.
  2. The procedures listed below are the LHD.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


2. REMOVE SPIRAL CABLE
  1. Remove the spiral cable (Click here).


3. REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY

  1. E155863
    Using a screwdriver, detach the claw and remove the windshield wiper switch.

    HINT:
    Tape the screwdriver tip before use.

    NOTICE:
    If the claw is pressed forcefully, it will break.


4. REMOVE HEADLIGHT DIMMER SWITCH ASSEMBLY

  1. E155864
    Disconnect the connector.

  1. E142947
    While loosening the band clamp as shown in the illustration, detach the claw to remove the dimmer switch.

    NOTICE:
    If the claw is pressed forcefully, it will break.

← COMPONENTS (from Sep 2011)INSPECTION (from Sep 2011) →