2011-2013 Land Cruiser · Service Manual Vehicle Exterior

INSTALLATION

Removal / installation · Vehicles built from Sep 2011

HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.


1. INSTALL REAR COMBINATION LIGHT SOCKET AND WIRE SUB-ASSEMBLY LH
  1. Attach the claw.

  1. Attach the 2 guide to install the rear combination light socket and wire sub-assembly LH.


2. INSTALL TAIL AND STOP LIGHT BULB

  1. E233685
    Install the tail and stop light bulb to the rear combination light socket and wire sub-assembly LH.

  1. Turn the rear combination light socket and wire sub-assembly LH in the direction indicated by the arrow in the illustration to install the socket.


3. INSTALL REAR TURN SIGNAL LIGHT BULB

  1. E233684
    Install the rear turn signal light bulb to the rear combination light socket and wire sub-assembly LH.

  1. Turn the rear combination light socket and wire sub-assembly LH in the direction indicated by the arrow in the illustration to install the socket.


4. INSTALL REAR COMBINATION LIGHT ASSEMBLY LH

  1. E235610E01
    Connect the connector.
    Text in Illustration 
    *1
    Protective tape

  1. Attach the 3 clips, 2 guides and 2 claws to install the rear combination light assembly LH.

    NOTICE:
    Attach the bolt installation bracket form outside the body while being careful not to bend it.

  1. Install the 2 bolts.

← REMOVAL (from Sep 2011)COMPONENTS (from Sep 2011) →