2011-2013 Land Cruiser · Service Manual Vehicle Exterior

INSTALLATION

Removal / installation · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

HINT:
  1. Use the same procedures for the RHD and LHD.
  2. The procedures listed below are the LHD side.


1. INSTALL HAZARD WARNING SIGNAL SWITCH ASSEMBLY

  1. E155869
    Attach the 2 claws to install the hazard warning switch.


2. INSTALL CENTER NO. 1 INSTRUMENT CLUSTER FINISH PANEL (w/o Radio Receiver)

B180653
  1. Connect the connector.

  1. Attach the 10 claws to install the No. 1 center instrument cluster finish panel.


3. INSTALL RADIO RECEIVER ASSEMBLY (w/ Radio Receiver)
  1. Connect the connectors.

  1. B181490
    Install the radio receiver with the 2 screws and 2 bolts.

    Torque:
    Bolt:
    12 N*m{ 122 kgf*cm , 9 ft.*lbf }


4. INSTALL NO. 4 INSTRUMENT PANEL REGISTER ASSEMBLY

B182866
  1. Connect the connector.

  1. Attach the 6 claws to install the No. 4 instrument panel register.


5. INSTALL NO. 3 INSTRUMENT PANEL REGISTER ASSEMBLY

B182547
  1. Connect the connector.

  1. Attach the 6 claws to install the No. 3 instrument panel register.


6. INSTALL NO. 1 SPEAKER OPENING COVER ASSEMBLY

B181531
  1. Attach the 4 claws to install the panel.


7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

← INSPECTION (from Sep 2011)INSTALLATION (from Jan 2012) →