2011-2013 Land Cruiser · Service Manual Vehicle Exterior

INSPECTION

Inspection · Vehicles built from Sep 2011


INSPECT HAZARD WARNING SIGNAL SWITCH ASSEMBLY

  1. E157013E01
    Inspect the hazard warning switch LED illumination.

    1. Apply battery voltage to the connector, and check the LED illumination condition.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → Terminal 3 (ILL+)
      Battery negative (-) → Terminal 2 (ILL-)
      Light illuminates

    2. E157013E02
      Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Switch Condition
      Specified Condition
      4 (F) - 1 (E)
      Hazard warning signal switch off
      10 kΩ or higher
      4 (F) - 1 (E)
      Hazard warning signal switch on
      Below 1 Ω

      If the result is not as specified, there may be a malfunction in the hazard warning switch.

← REMOVAL (from Jan 2012)INSTALLATION (Sep 2011 – Dec 2011) →