INSTALLATION
Removal / installation · Vehicles built from Sep 2011
| 1. INSTALL STOP LIGHT SWITCH MOUNTING ADJUSTER |
Install a stop light switch mounting adjuster to the pedal support.
| 2. INSTALL STOP LIGHT SWITCH |
Insert the stop light switch to the adjuster until it just touches the brake pedal.

- NOTICE:
- Do not depress the brake pedal.
Turn the stop light switch quarter in clockwise to install it.

- NOTICE:
- Do not depress the brake pedal.
- Do not apply thrust force 98 N (9.99 kgf) or more to the switch body.
- Do not apply silicone grease on the switch body.
- Do not depress the brake pedal.
- Torque:
- 1.5 N*m{ 15 kgf*cm , 13 in.*lbf }
Check the stop light switch clearance.
- Stop light switch clearance:
- 1.5 to 2.5 mm (0.0590 to 0.0984 in.)
Connect the wire harness clamp to the pedal support.
Connect the connector to the stop light switch.
