2011-2013 Land Cruiser · Service Manual Power Source / Network

U0114/38 Lost Communication with 4WD Control ECU

Diagnostic trouble codes · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

DTC Code
DTC Detection Condition
Trouble Area
U0114/38
There is no communication from the 4WD control ECU.
  1. Power source circuit of 4WD control ECU
  2. 4WD control ECU
  3. 4WD control ECU branch wire or connector

WIRING DIAGRAM

C158952E03

INSPECTION PROCEDURE


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
  1. Disconnect the cable from the negative (-) battery terminal before measuring the resistances of the main wire and the branch wire.

    CAUTION:
    For vehicles with an SRS system:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    NOTICE:
    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


NEXT


2. CHECK FOR OPEN IN CAN BUS WIRE (4WD CONTROL ECU BRANCH WIRE)
C159487E09
  1. Disconnect the A27 4WD control ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    A27-19 (CAN+) - A27-20 (CAN-)
    Ignition switch off
    54 to 69 Ω



NG
REPAIR OR REPLACE 4WD CONTROL ECU BRANCH WIRE OR CONNECTOR (CAN+, CAN-)
OK


3. CHECK HARNESS AND CONNECTOR (4WD CONTROL ECU - BATTERY AND BODY GROUND)
  1. Connect the cable to the negative (-) battery terminal.

    NOTICE:
    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  1. C162021E02
    Disconnect the A28 4WD control ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A28-4 (GND) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    A28-3 (IG) - Body ground
    Ignition switch ON
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE 4WD CONTROL ECU (Click here)


← U0104 Lost Communication with Driving Support ECU (from Jan 2012)U0114/38 Lost Communication with 4WD Control ECU (from Jan 2012) →