2011-2013 Land Cruiser · Service Manual Vehicle Interior

INSTALLATION

Removal / installation · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.

HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicles.
  3. Use the same procedure for the RH and LH sides.
  4. The procedure listed below is for the LH side.


1. INSTALL FRONT SEAT ASSEMBLY LH
  1. Place the front seat assembly in the cabin.

    NOTICE:
    Be careful not to damage the vehicle body.

  1. Connect the seat wire connectors under the seat.

  1. Connect the cable to the negative (-) battery terminal.

    NOTICE:
    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  1. Temporarily install the front seat assembly with the 4 bolts.

  1. Operate the power seat switch (slide switch) to move the seat to the rearmost position.

  1. B187250E01
    Tighten the bolts in the order shown in the illustration.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }

  1. Operate the power seat switch (slide switch) to move the seat to the foremost position.

  1. B187249E01
    Tighten the bolts in the order shown in the illustration.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }


2. INSTALL REAR INNER SEAT TRACK BRACKET COVER LH

B180737
  1. Attach the 2 claws to install the cover.


3. INSTALL REAR OUTER SEAT TRACK BRACKET COVER LH

B180736
  1. Attach the 2 claws to install the cover.


4. INSTALL FRONT INNER SEAT TRACK BRACKET COVER LH

B180739
  1. Attach the 2 claws to install the cover.


5. INSTALL FRONT OUTER SEAT TRACK BRACKET COVER LH

B180738
  1. Attach the 2 claws to install the cover.

  1. Restore the Autoaway/Return function setting to the previous condition by changing the customize parameter (Click here).


6. INSTALL FRONT SEAT HEADREST ASSEMBLY
  1. Install the front seat headrest.


7. CHECK SRS WARNING LIGHT
  1. Check the SRS warning light (Click here).


8. INSPECT FRONT SEAT ASSEMBLY
  1. w/ Seat Position Memory System:
    Check the power seat operation (Click here).

  1. w/o Seat Position Memory System:
    Check the power seat operation (Click here).

  1. w/ Seat Heater System:
    Check the seat heater operation.

    1. Turn the ignition switch to ON.

    2. Turn the seat heater switch on.

    3. Wait 5 minutes or more and confirm that the seat surface becomes warm.

← REASSEMBLY (from Jan 2012)INSTALLATION (from Jan 2012) →