2011-2013 Land Cruiser · Service Manual Vehicle Interior

REMOVAL

Removal / installation · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.

HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicles.
  3. Use the same procedure for the RH and LH sides.
  4. The procedure listed below is for the LH side.


1. REMOVE FRONT SEAT HEADREST ASSEMBLY
  1. Remove the front seat headrest.


2. REMOVE REAR OUTER SEAT TRACK BRACKET COVER LH
  1. Operate the power seat switch (slide switch) to move the seat to the foremost position.

  1. B180694
    Using a screwdriver, detach the 2 claws and remove the cover.

    HINT:
    Tape the screwdriver tip before use.


3. REMOVE REAR INNER SEAT TRACK BRACKET COVER LH

  1. B180693
    Using a screwdriver, detach the 2 claws and remove the cover.

    HINT:
    Tape the screwdriver tip before use.


4. REMOVE FRONT OUTER SEAT TRACK BRACKET COVER LH
  1. Operate the power seat switch (slide switch) to move the seat to the rearmost position.

  1. B180696
    Using a screwdriver, detach the 2 claws and remove the cover.

    HINT:
    Tape the screwdriver tip before use.


5. REMOVE FRONT INNER SEAT TRACK BRACKET COVER LH

  1. B180695
    Using a screwdriver, detach the 2 claws and remove the cover.

    HINT:
    Tape the screwdriver tip before use.


6. REMOVE FRONT SEAT ASSEMBLY LH
  1. Disable the Autoaway/Return function by changing the customize parameter (Click here).

    NOTICE:
    Record the current customize parameter setting (whether the Autoaway/Return function is enabled or disabled) in order to restore the current setting after finishing the operation.

    HINT:
    Performing the above operation causes the Autoaway/Return function to be disabled when the ignition switch is turned off.

  1. Turn the ignition switch to ON. Operate the tilt and telescopic switch to fully retract and tilt up the steering column assembly.

  1. Turn the ignition switch off.

  1. B180714
    Remove the 2 bolts.

  1. Operate the power seat switch (slide switch) to move the seat to the foremost position.

  1. B180715
    Remove the 2 bolts.

  1. Operate the power seat switch (slide switch) and move the seat to the center position, and operate the power seat switch (reclining switch) and move the seatback to the upright position.

  1. Disconnect the cable from the negative (-) battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    NOTICE:
    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  1. Disconnect the connectors under the seat.

  1. Remove the front seat assembly.

    NOTICE:
    Be careful not to damage the vehicle body.

← COMPONENTS (from Jan 2012)REMOVAL (from Jan 2012) →