2011-2013 Land Cruiser · Service Manual Vehicle Interior

REMOVAL

Removal / installation · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.

HINT:
  1. Use the same procedures for LHD and RHD vehicles.
  2. The procedures listed below are for LHD vehicles.


1. REMOVE FRONT SEAT ASSEMBLY LH
  1. Remove the front seat assembly LH (Click here).


2. REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB

B180697E02
  1. Apply protective tape as shown in the illustration.

    Text in Illustration 
    *1
    Protective Tape

  1. Using a screwdriver, detach the 2 claws and remove the slide and vertical power seat switch knob.

    HINT:
    Tape the screwdriver tip before use.


3. REMOVE RECLINING POWER SEAT SWITCH KNOB

B180698E02
  1. Using a screwdriver, detach the 2 claws and remove the reclining power seat switch knob.

    Text in Illustration 
    *1
    Protective Tape

    HINT:
    Tape the screwdriver tip before use.


4. REMOVE FRONT SEAT CUSHION SHIELD LH

B180699
  1. Remove the 2 screws.

  1. Disconnect the 2 rubber bands.

  1. B180700
    Remove the 3 screws.

  1. Detach the 2 claws and remove the front seat cushion shield LH together with the front inner No. 1 seat cushion shield LH.

  1. for Driver Side:
    Disconnect the connector.


5. REMOVE FRONT SEAT INNER BELT ASSEMBLY LH
  1. Disconnect the connectors and detach the clamps.

  1. B185874
    Remove the nut and front seat inner belt assembly.


6. REMOVE FRONT INNER SEAT CUSHION SHIELD LH

B180703
  1. Remove the screw.

  1. Detach the 2 claws and clip, and then remove the front inner seat cushion shield LH.


7. REMOVE FRONT SEATBACK BOARD SUB-ASSEMBLY LH

B180711
  1. Remove the 2 screws.

  1. Move the front seatback board sub-assembly LH in the direction of the arrow to detach the 2 hooks and remove it.


8. REMOVE FRONT SEAT HEADREST SUPPORT

B180712
  1. Detach the 4 claws and remove the 2 front seat headrest supports.


9. REMOVE SEATBACK COVER WITH PAD

  1. B180713E02
    Remove the hog rings.
    Text in Illustration 
    *1
    Hog Ring

  1. B180716E01
    Remove the nut and detach the seatback cover bracket.
    Text in Illustration 
    *1
    Seatback Cover Bracket

  1. Detach the hooks and remove the seatback cover with pad.


10. REMOVE FRONT SEATBACK PROTECTOR (w/ Climate Control Seat System)

B299469E01
  1. Remove the front seatback protector.

  1. Remove any remaining double-sided tape.

    Text in Illustration 
    *1
    Double-sided Tape


11. REMOVE SEAT CLIMATE CONTROL CONTROLLER LH (w/ Climate Control Seat System)

B299480
  1. Detach the 4 claws and disconnect the seat climate control blower LH.

  1. B299481
    Detach the wire harness clamp.

  1. Remove the 2 screws and seat climate control controller LH.


12. REMOVE FRONT SEAT AIRBAG ASSEMBLY LH

  1. B102196
    Detach the 5 clamps and disconnect the wire harness.

  1. B102199
    Detach the 2 clamps and disconnect the wire harness.

  1. Remove the 2 nuts and front seat airbag assembly LH.

    CAUTION:
    Make sure that the seat frame assembly is not deformed. If it is, replace it with a new one.

← REMOVAL (Sep 2011 – Dec 2011)INSTALLATION (Sep 2011 – Dec 2011) →