2011-2013 Land Cruiser · Service Manual Vehicle Interior

INSTALLATION

Removal / installation · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.

HINT:
  1. Use the same procedures for LHD and RHD vehicles.
  2. The procedures listed below are for LHD vehicles.


1. INSTALL FRONT SEAT AIRBAG ASSEMBLY LH

CAUTION:
Make sure that the seat frame assembly is not deformed. If it is, replace it with a new one.

  1. B102199
    Install the front seat airbag assembly with 2 nuts.

    Torque:
    5.5 N*m{ 56 kgf*cm , 49 in.*lbf }

  1. Attach the 2 clamps to connect the wire harness.

  1. B102196
    Attach the 5 clamps to connect the wire harness.


2. INSTALL SEATBACK COVER WITH PAD
  1. Install the seatback cover with pad to the seatback frame.

  1. B180716
    Install the seatback cover bracket to the seat frame with the nut.

    Torque:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }

    CAUTION:
    After the seatback cover with pad is installed, make sure the seatback cover bracket is not twisted.

  1. B180713E01
    Attach the 9 hooks.

  1. Using hog ring pliers, install new hog rings to the seat frame.


3. INSTALL FRONT SEAT HEADREST SUPPORT
  1. Attach the 4 claws to install the 2 headrest supports.


4. INSTALL FRONT SEATBACK BOARD SUB-ASSEMBLY LH

B182646
  1. Move the seatback board in the direction of the arrow to attach the 2 hooks and install the seatback board.

  1. Install the 2 screws.


5. INSTALL FRONT INNER SEAT CUSHION SHIELD LH

B180703
  1. Attach the 2 claws and clip to install the cushion shield.

  1. Install the screw.


6. INSTALL FRONT SEAT INNER BELT ASSEMBLY LH

B185875E01
  1. Install the front seat inner belt assembly with the nut.

    Torque:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }

    NOTICE:
    Do not allow the anchor part of the front seat inner belt assembly to overlap the protruding parts of the front seat adjuster.

  1. Connect the connectors and attach the clamps.


7. INSTALL FRONT SEAT CUSHION SHIELD LH

  1. B180700
    for Driver Side:
    Connect the lumbar switch connectors.

  1. Attach the 2 claws to install the cushion shield.

  1. Install the 3 screws.

  1. B180699
    Install the 2 screws.

  1. Connect the 2 rubber bands to the 2 hooks.


8. INSTALL RECLINING POWER SEAT SWITCH KNOB

B180734
  1. Attach the 2 claws to install the knob.


9. INSTALL SLIDE AND VERTICAL POWER SEAT SWITCH KNOB

B180735
  1. Attach the 2 claws to install the knob.


10. INSTALL FRONT SEAT ASSEMBLY LH
  1. Install the front seat assembly LH (Click here).

← REMOVAL (from Jan 2012)INSTALLATION (from Jan 2012) →