2011-2013 Land Cruiser · Service Manual Vehicle Interior

REMOVAL

Removal / installation · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.

HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicles.
  3. Use the same procedure for the RH and LH sides.
  4. The procedure listed below is for the LH side.


1. REMOVE FRONT SEAT ASSEMBLY LH
  1. Remove the front seat assembly (Click here).


2. REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB

B180697E01
  1. Apply protective tape around the cushion shield.

  1. Using a screwdriver, detach the 2 claws and remove the knob.

    HINT:
    Tape the screwdriver tip before use.


3. REMOVE RECLINING POWER SEAT SWITCH KNOB

B180698E01
  1. Using a screwdriver, detach the 2 claws and remove the knob.

    HINT:
    Tape the screwdriver tip before use.


4. REMOVE FRONT SEAT CUSHION SHIELD LH

B180699
  1. Disconnect the 2 rubber bands from the 2 hooks.

  1. Remove the 2 screws.

  1. B180700
    Remove the 3 screws.

  1. Detach the 2 claws and remove the cushion shield.

  1. for Driver Side:
    Disconnect the lumbar switch connector.


5. REMOVE FRONT SEAT INNER BELT ASSEMBLY LH
  1. Disconnect the connectors and detach the clamps.

  1. B185874
    Remove the nut and front seat inner belt assembly.


6. REMOVE FRONT INNER SEAT CUSHION SHIELD LH

B180703
  1. Remove the screw.

  1. Detach the 2 claws and clip, and then remove the cushion shield.


7. REMOVE FRONT POWER SEAT SWITCH LH

B180704
  1. w/ Seat Position Memory System:
    Disconnect the 2 connectors.

  1. w/o Seat Position Memory System:
    Disconnect the connector.

  1. Remove the 3 screws and switch.


8. REMOVE SEAT CUSHION COVER WITH PAD

  1. B180705
    Using a clip remover, remove the 2 clips.

  1. B180706
    Disconnect the seat heater connector and detach the 2 wire harness clamps.

  1. B180707
    Disconnect the seat heater control connector and detach the wire harness clamp.

  1. B180765
    for Front Passenger Side:
    Detach the 2 clamps and remove the connector holder.

  1. B180708
    Bend the 2 seat frame claws upward.

  1. Detach the hooks and remove the seat cushion cover with pad.


9. REMOVE FRONT SEPARATE TYPE SEAT CUSHION COVER

  1. B180709
    Remove the hog rings and front seat cushion cover.


10. REMOVE FRONT SEAT CUSHION HEATER ASSEMBLY LH

  1. B180710
    Cut off the tack pins which fasten the seat heater to the seat cushion cover, and then remove the seat cushion heater from the seat cushion cover.

← COMPONENTS (from Sep 2011)REMOVAL (from Jan 2012) →