2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

INSTALLATION

Removal / installation · Vehicles built from Jan 2012

HINT:
  1. Use the same procedure for both the RH and LH sides.
  2. The procedure described below is for the LH side.


1. INSTALL SIDE TELEVISION CAMERA ASSEMBLY
  1. Install the side television camera with the 3 screws.

  1. Connect the connector.

  1. Install the body

    1. Attach the 2 guides and body.

      NOTICE:
      Be careful not to break the guide.

  1. Install the body cover

    1. Install the body with the 5 screws.

  1. B278341
    Connect the connector.

  1. Attach the connector to the wire clip.

  1. Install the base

    1. Attach the guide.

    2. Using "TORX" socket wrench T25, install the base with 3 new screws.

      NOTICE:
      When installing the base, check that the wire harness is not caught between the base and housing. Failure to do so may cause a short circuit.

  1. Install the lower mirror cover

    1. Attach the 4 claws and install the new lower mirror cover.

  1. Install the gasket

    1. Attach the 9 guides and install the gasket.

    2. B278323E02
      Align the marking on the wire harness with the marking on the end of the wire harness insertion hole of the gasket as shown in the illustration, and wrap them with new vinyl tape starting from the gasket marking.
      Text in Illustration 
      *1
      New Vinyl Tape
      *a
      Marking

      Standard:
      Area
      Specified Condition
      a
      50.0 mm (1.97 in.)

      NOTICE:
      If the vinyl tape is wrinkled, water may run down the wire harness and enter the vehicle. Make sure to wind the vinyl tape properly.

    3. B302367E01
      Wrap new vinyl tape as shown in the illustration.
      Text in Illustration 
      *1
      New Vinyl Tape

      Standard:
      Area
      Specified Condition
      a
      30.0 mm (1.18 in.)
      b
      50.0 mm (1.97 in.)


2. INSTALL SIDE TURN SIGNAL LIGHT ASSEMBLY LH
  1. Connect the connector.

  1. Install the light with the 3 screws.


3. INSTALL OUTER MIRROR COVER LH

  1. Install the outer mirror cover.

    1. B302369E01
      Insert the rib on the outer edge of the cover into the groove of the mirror body.

      NOTICE:
      Do not scratch the turn light.

      Text in Illustration 
      *1
      Rib

    2. B302371
      While making sure that the rib of the cover fits properly into the groove of the mirror body, squeeze the inner end of the cover and the mirror body together to attach the inner claws.

  1. B302372
    Push on the cover at the locations of the 8 claws to confirm that the claws are attached properly.

  1. Check that there is no gap between the cover and mirror body.

    HINT:
    If there is a gap between the cover and body, noise will occur during driving.


4. INSTALL OUTER MIRROR LH

B189668
  1. w/ EC Mirror:
    Connect the connector.

  1. B189669
    w/ Mirror Heater:
    Connect the 2 connectors.

  1. B183885
    Attach the 4 claws to install the outer mirror LH.


5. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY LH
(Click here)

6. ADJUST SIDE TELEVISION CAMERA ASSEMBLY
(Click here
← REMOVAL (from Jan 2012)COMPONENTS (from Sep 2011) →