2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

INSPECTION

Inspection · Vehicles built from Jan 2012


INSPECT PURGE VSV
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    20°C (68°F)
    23 to 26 Ω
    1 - Body ground
    Always
    10 MΩ or higher
    2 - Body ground

    HINT:
    When measuring the coil resistance, make sure that the surface temperature of the purge VSV is 20°C (68°F).

    If the result is not as specified, replace the purge VSV.

  1. Check the operation of the purge VSV.

    1. A214835E02
      Check that air does not flow from port E to port F.
      Text in Illustration 
      *1
      Port E
      *2
      Port F
      *a
      Does not flow
      V100135
      Air pressure

    2. A273505E01
      Apply battery voltage to the connector and check the VSV operation.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → Terminal 1
      Battery negative (-) → Terminal 2
      Air flows from port E to port F

      Text in Illustration 
      *1
      Port E
      *2
      Port F
      V100135
      Air pressure
      If the result is not as specified, replace the purge VSV.

← REMOVAL (from Jan 2012)INSTALLATION (from Jan 2012) →