2011-2013 Land Cruiser · Service Manual Vehicle Interior

INSTALLATION

Removal / installation · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

HINT:
  1. Use the same procedures for the LH side and RH side.
  2. The procedures listed below are for the LH side.
  3. A bolt without a torque specification is shown in the standard bolt chart (Click here).


1. INSTALL REAR NO. 2 SEAT OUTER BELT ASSEMBLY LH

B180639E01
  1. Align the claws with the seat belt positioning holes and install the retractor of the seat belt as shown in the illustration.

  1. Install the seat belt with the bolt.

    Torque:
    42 N*m{ 427 kgf*cm , 31 ft.*lbf }

  1. B183809
    Install the seat belt shoulder anchor with the bolt.

    Torque:
    42 N*m{ 427 kgf*cm , 31 ft.*lbf }

  1. B183996
    Attach the 2 claws to close the seat belt shoulder anchor cover.


2. INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY LH

B182644

HINT:
When installing the front quarter trim panel, operate the reclining adjuster release handle and move the No. 1 rear seat to the position shown in the illustration.

  1. w/o Rear Air Conditioning System:
    Connect the rear seat lock control lever cable.

  1. w/ Rear Air Conditioning System:
    Connect the thermistor connector and rear seat lock control lever cable.

  1. Attach the 18 clips and 2 claws to install the quarter trim panel.

  1. Install the clip and bolt.

    Torque:
    12 N*m{ 122 kgf*cm , 9 ft.*lbf }


    B186889

  1. B181691E01
    for LH Side:

    1. Install the rear No. 2 seat belt anchor LH with the bolt.

      Torque:
      42 N*m{ 428 kgf*cm , 31 ft.*lbf }

      NOTICE:
      Do not overlap the anchor part of the seat belt and protruding parts of the vehicle body.

  1. B181693
    for RH Side:

    1. Install the rear No. 2 seat belt anchor RH with the bolt.

      Torque:
      42 N*m{ 428 kgf*cm , 31 ft.*lbf }

    2. B181692
      Attach the 3 claws to install the cover.

  1. B181689
    Install the rear No. 1 seat belt anchor with the bolt.

    Torque:
    42 N*m{ 428 kgf*cm , 31 ft.*lbf }

  1. B181687
    Attach the 3 claws to install the cover.


3. INSTALL REAR NO. 2 SEAT COVER BEZEL

B181698
  1. Attach the 6 clips to install the rear No. 2 seat cover bezel.


4. INSTALL REAR DOOR SCUFF PLATE LH

B181674
  1. Attach the 3 claws and 4 clips to install the scuff plate.

  1. Install the screw.


5. INSTALL REAR STEP COVER

B181673

HINT:
Use the same procedure to install the step cover on the other side.

  1. Attach the 2 claws to install the step cover.


6. INSTALL REAR FLOOR MAT REAR SUPPORT PLATE

B181672
  1. Attach the 6 clips to install the support plate.


7. INSTALL REAR NO. 2 SEAT ASSEMBLY
  1. Install the rear No. 2 seat assembly (Click here).

← INSPECTION (from Sep 2011)INSTALLATION (from Jan 2012) →