2011-2013 Land Cruiser · Service Manual Vehicle Interior

INSTALLATION

Removal / installation · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.

HINT:
  1. Use the same procedure for the RH and LH sides.
  2. The procedure listed below is for the LH side.


1. INSTALL REAR SEAT LOCK STRIKER SUB-ASSEMBLY
  1. Install the 4 seat lock strikers with 8 bolts.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }

  1. Return the floor carpet to its original position.


2. INSTALL NO. 3 SEAT CUSHION COVER
  1. Attach the 16 claws and 4 clips to install the 4 seat cushion covers.


3. INSTALL FOLD SEAT LEG LOCK SUB-ASSEMBLY
  1. Install the fold seat leg lock with the 2 nuts.

    Torque:
    12 N*m{ 122 kgf*cm , 9 ft.*lbf }

  1. Attach the 2 cable clamps.


4. INSTALL REAR ROOF NO. 1 AIR DUCT (w/ Rear Air Conditioning System)

E154870
  1. Install the duct with the clip.

  1. E154869
    Attach the 2 claws to install the cooler plate.


5. INSTALL REAR SEAT LOCK CONTROL LEVER SUB-ASSEMBLY LH
  1. Attach the 4 claws to install the seat lock control lever.


6. INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY LH
  1. w/ Sliding Roof:
    Install the front quarter trim panel assembly LH (Click here).

  1. w/o Sliding Roof:
    Install the front quarter trim panel assembly LH (Click here).


7. INSTALL REAR SEAT COVER CAP

B190214

HINT:
Use the same procedure to install the rear seat cover cap on the other side.

  1. Attach the 3 claws to install the rear seat cover cap.


8. INSTALL REAR FLOOR MAT REAR SUPPORT PLATE

B181672
  1. Attach the 6 clips to install the support plate.


9. INSTALL REAR DOOR SCUFF PLATE LH

B181674
  1. Attach the 3 claws and 4 clips to install the scuff plate.

  1. Install the screw.


10. INSTALL REAR STEP COVER

B181673

HINT:
Use the same procedure to install the step cover on the other side.

  1. Attach the 2 claws to install the step cover.


11. INSTALL REAR NO. 2 SEAT ASSEMBLY

B181811E01
  1. Temporarily install the seat assembly with the 4 bolts.

    NOTICE:
    Be careful not to damage the vehicle body.

  1. Tighten the bolts in the order shown in the illustration.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }


12. INSTALL REAR NO. 2 SEAT HINGE COVER LH
  1. Attach the clip and 2 claws to install the cover.


13. INSTALL REAR SEAT CUSHION HINGE COVER LH
  1. Attach the 3 claws to install the cover.

  1. Return the seat to the upright position.


14. INSTALL REAR NO. 2 SEAT HEADREST ASSEMBLY LH (w/ Rear Center Seat Headrest)
← REASSEMBLY (from Sep 2011)INSTALLATION (from Jan 2012) →