Use the same procedures for the LH side and RH side.
The procedures listed below are for the LH side.
1.
INSTALL REAR DOOR OUTSIDE HANDLE ASSEMBLY LH
Insert the front end of the rear door outside handle assembly into the rear door outside handle frame.
NOTICE:
If the bellcrank lever is not pulled and held when installing the outside handle, the bellcrank lever will interfere with the outside handle and the release plate may be damaged.
Insert the rear end of the rear door outside handle assembly into the rear door outside handle frame. Next, slide the rear door outside handle assembly toward the front of the vehicle to install it.
Using a T30 ''TORX'' socket, tighten the screw.
Connect the connector.
2.
INSTALL REAR DOOR OUTSIDE HANDLE COVER LH
Attach the claw to install the rear door outside handle cover.
Using a T30 ''TORX'' socket, install the cover with the screw.
3.
INSTALL REAR DOOR LOCK ASSEMBLY LH
Apply MP grease to the sliding parts of the rear door lock assembly.
Insert the rear door lock assembly to the rear door outside handle release plate, and set it to the rear door panel.
Make sure that the rear door outside handle frame release plate is securely connected to the rear door lock assembly.
Using a T30 ''TORX'' wrench, the 3 screws.
Torque:
5.0 N*m{
51 kgf*cm
, 44 in.*lbf
}
4.
INSTALL REAR DOOR SERVICE HOLE COVER LH
Apply butyl tape to the door.
Pass the rear door lock remote control cable and rear door inside locking cable through a new rear door service hole cover.
NOTICE:
When installing the service hole cover, pull the links and connectors through the service hole cover.
There should be no wrinkles or folds after attaching the service hole cover.
After attaching the service hole cover, check the sealing quality.