2011-2013 Land Cruiser · Service Manual Vehicle Interior

INSTALLATION

Removal / installation · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

NOTICE:
  1. When installing a new back door lock assembly, if there is any tape stuck to it, remove the tape.
  2. When installing a new back door lock assembly, if there are any strings attached to it, cut the strings off.


1. INSTALL BACK DOOR LOCK PROTECTOR (w/ Power Back Door)
  1. Attach the 2 claws to install the protector (A).

  1. Attach the 7 claws to install the protector (B).

  1. Install the screw.


2. INSTALL BACK DOOR LOCK ASSEMBLY
  1. w/o Power Back Door:

    1. Install the back door lock assembly with the 3 bolts.

      Torque:
      13 N*m{ 133 kgf*cm , 10 ft.*lbf }

    2. Connect the connector.

  1. w/ Power Back Door:

    1. Install the back door lock assembly with the 4 bolts.

      Torque:
      13 N*m{ 133 kgf*cm , 10 ft.*lbf }

    2. Attach the guide.

    3. Connect the connector.


3. INSTALL BACK DOOR LOCK COVER
  1. Attach the 4 claws to install the back door lock cover.


4. INSTALL REAR ASSIST GRIP REINFORCEMENT (for Face to Face Seat Type)
  1. Attach the 2 claws to install the rear assist grip reinforcement.

  1. Install the 3 bolts.


5. INSTALL BACK DOOR GARNISH
  1. Attach the 14 clips to install the back door garnish.


6. INSTALL DOOR OPENING SWITCH SUB-ASSEMBLY (for Face to Face Seat Type)
  1. Attach the 2 claws to install the door opening switch sub-assembly.


7. INSTALL NO. 2 BACK DOOR SERVICE HOLE COVER (for Face to Face Seat Type)
  1. Connect the connector.

  1. Attach the 4 claws to install the No. 2 back door service hole cover.


8. INSTALL ASSIST GRIP (for Face to Face Seat Type)
  1. Install the assist grip with the 2 screws.


9. INSTALL BACK DOOR SIDE GARNISH RH
  1. w/o Power Back Door:

    HINT:
    Use the same procedure described for the LH side.

  1. w/ Power Back Door:

    1. Attach the clip and 4 claws to install the back door side garnish RH.


10. INSTALL BACK DOOR SIDE GARNISH LH
  1. Attach the 3 clips and 2 claws to install the back door side garnish LH.


11. INSTALL CENTER BACK DOOR GARNISH
  1. Attach the 5 clips and 4 claws to install the center back door garnish.

← INSTALLATION (Sep 2011 – Dec 2011)COMPONENTS (from Sep 2011) →