INSTALLATION
Removal / installation · Vehicles built Sep 2011 – Dec 2011
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
- HINT:
- Use the same procedures for LHD and RHD vehicles.
- The procedures listed below are for LHD vehicles.
- Use the same procedures for LHD and RHD vehicles.
| 1. INSTALL WIRELESS DOOR LOCK BUZZER |
Connect the connector.

Attach the clamp to install the buzzer.
| 2. INSTALL FRONT BUMPER COVER |
![]() ![]() |
- HINT:
- For the front bumper cover with garnish, use the procedures described below.
w/ Headlight Cleaner System:
Connect the headlight cleaner hose.
w/o TOYOTA Parking Assist-sensor System, w/o Fog Light:
Attach the 10 claws to install the bumper cover.
w/ TOYOTA Parking Assist-sensor System or w/ Fog Light:
Connect the No. 4 engine room wire connector and attach the 10 claws to install the bumper cover.
Install the 3 clips, 4 screws and 4 bolts.


Using a T30 "TORX" socket, install the 6 screws.


| 3. INSTALL RADIATOR GRILLE ASSEMBLY |
![]() ![]() |
Attach the 2 clips and 8 claws to install the radiator grille.
Install the 3 screws.
| 4. INSTALL UPPER RADIATOR SUPPORT SEAL |
Install the radiator support seal with the 7 clips.


| 5. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH |
![]() ![]() |
Push in the clip indicated by the arrow in the illustration to install the fender splash shield.
Install the 3 bolts and screw.
| 6. INSTALL FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH |
- HINT:
- Use the same procedures described for the LH side.



