2011-2013 Land Cruiser · Service Manual Vehicle Interior

REMOVAL

Removal / installation · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

HINT:
  1. Use the same procedures for LHD and RHD vehicles.
  2. The procedures listed below are for LHD vehicles.


1. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH

  1. B310791
    Remove the 3 bolts and screw.

  1. Turn the clip indicated by the arrow in the illustration to remove the front fender splash shield sub-assembly LH.


2. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH

  1. B310792
    Remove the 3 bolts and 2 screws.

  1. Turn the clip indicated by the arrow in the illustration to remove the front fender splash shield sub-assembly RH.


3. REMOVE UPPER RADIATOR SUPPORT SEAL

  1. Remove the 7 clips and radiator support seal.

    B180890E02


4. REMOVE RADIATOR GRILLE ASSEMBLY

  1. B302174E01
    Put protective tape around the radiator grille assembly.
    Text in Illustration 
    *1
    Protective Tape

  1. Remove the 3 screws.

  1. Detach the 2 clips and 8 claws, and remove the radiator grille assembly.

  1. w/ Wide View Front Monitor System:

    1. Disconnect the connector.


5. REMOVE FRONT BUMPER COVER

HINT:
For the front bumper cover with garnish, use the procedure described below.

  1. Put protective tape around the front bumper cover.

    B302149E01

    Text in Illustration 
    *1
    Protective Tape
    -
    -

  1. Using a T30 "TORX" socket, remove the 6 screws.

    B313279E01

    Text in Illustration 
    *A
    LH Side
    *B
    RH Side

  1. Remove the 3 clips, 4 screws and 4 bolts.

  1. Detach the 10 claws and remove the front bumper cover.

    B302150

  1. w/ TOYOTA Parking Assist-sensor System or w/ Fog Light:
    Disconnect the No. 4 engine room wire connector and remove the front bumper cover.

  1. B181927
    w/ Headlight Cleaner System:
    Disconnect the headlight cleaner hose and remove the front bumper cover.


6. REMOVE WIRELESS DOOR LOCK BUZZER

  1. B180442
    Disconnect the connector.

  1. Detach the clamp and remove the buzzer.

← REMOVAL (Sep 2011 – Dec 2011)INSTALLATION (Sep 2011 – Dec 2011) →