2011-2013 Land Cruiser · Service Manual Vehicle Interior

REMOVAL

Removal / installation · Vehicles built from Sep 2011

HINT:
  1. Use the same procedures for LHD and RHD vehicles.
  2. The procedures listed below are for LHD vehicles.


1. REMOVE NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION

B292994E01
  1. Put protective tape around the No. 2 instrument panel finish panel cushion.

    Text in Illustration 
    *1
    Protective Tape

  1. Using a moulding remover, detach the 7 claws and remove the No. 2 instrument panel finish panel cushion.


2. REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH

B292995
  1. Remove the clip and screw.

  1. Detach the 8 claws.

  1. Disconnect the connectors, detach the 2 clamps and remove the lower instrument panel pad sub-assembly.


3. REMOVE NO. 1 INSTRUMENT PANEL FINISH PANEL CUSHION

B180004E02
  1. Put protective tape around the No. 1 instrument panel finish panel cushion.

    Text in Illustration 
    *1
    Protective Tape

  1. Using a moulding remover, detach the 7 claws and remove the No. 1 instrument panel finish panel cushion.


4. REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH

B180005
  1. Remove the clip and screw.

  1. Detach the 7 claws and remove the lower instrument panel pad sub-assembly.


5. REMOVE LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

B292996
  1. Detach the 7 claws.

  1. Disconnect the connectors and remove the lower center instrument cluster finish panel sub-assembly.


6. REMOVE POWER OUTLET SOCKET ASSEMBLY

  1. B174128
    Rotate the socket to disengage the notch.

  1. B108949
    Pull out the socket halfway and rotate the socket until its protrusion is aligned with the groove of the cover. Then remove the power outlet socket.


7. REMOVE POWER OUTLET SOCKET COVER NO.2

  1. B178637
    Detach the 2 claws and remove the cover.

← COMPONENTS (from Sep 2011)INSTALLATION (from Sep 2011) →