REMOVAL
Removal / installation · Vehicles built from Sep 2011
- HINT:
- Use the same procedures for LHD and RHD vehicles.
- The procedures listed below are for LHD vehicles.
- Use the same procedures for LHD and RHD vehicles.
| 1. REMOVE NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION |
![]() ![]() |
Put protective tape around the No. 2 instrument panel finish panel cushion.
Text in Illustration *1
Protective Tape
Using a moulding remover, detach the 7 claws and remove the No. 2 instrument panel finish panel cushion.
| 2. REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH |
![]() ![]() |
Remove the clip and screw.
Detach the 8 claws.
Disconnect the connectors, detach the 2 clamps and remove the lower instrument panel pad sub-assembly.
| 3. REMOVE NO. 1 INSTRUMENT PANEL FINISH PANEL CUSHION |
![]() ![]() |
Put protective tape around the No. 1 instrument panel finish panel cushion.
Text in Illustration *1
Protective Tape
Using a moulding remover, detach the 7 claws and remove the No. 1 instrument panel finish panel cushion.
| 4. REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH |
![]() ![]() |
Remove the clip and screw.
Detach the 7 claws and remove the lower instrument panel pad sub-assembly.
| 5. REMOVE LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY |
![]() ![]() |
Detach the 7 claws.
Disconnect the connectors and remove the lower center instrument cluster finish panel sub-assembly.
| 6. REMOVE CIGARETTE LIGHTER COVER |
Detach the 2 claws and remove the cover.

| 7. REMOVE CIGARETTE LIGHTER ASSEMBLY |
Remove the cigarette lighter knob and element assembly.
Using a screwdriver, detach the claw, and remove the cigarette lighter socket and retainer assembly.

- HINT:
- Tape the screwdriver tip before use.
| 8. REMOVE CIGARETTE LIGHTER BEZEL STAY |
Detach the 2 claws and remove the bezel stay.






