REMOVAL
Removal / installation · Vehicles built from Jan 2012
| 1. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH |
Remove the 3 bolts and screw.

Turn the clip indicated by the arrow in the illustration to remove the front fender splash shield sub-assembly LH.
| 2. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH |
Remove the 3 bolts and 2 screws.

Turn the clip indicated by the arrow in the illustration to remove the front fender splash shield sub-assembly RH.
| 3. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY |
Remove the 10 bolts and No. 1 engine under cover sub-assembly.

| 4. REMOVE NO. 2 ENGINE UNDER COVER |
Remove the 2 bolts and No. 2 engine under cover.

| 5. DRAIN ENGINE OIL |
Remove the oil filler cap.
Remove the 2 bolts and No. 2 engine under cover seal.

Remove the oil pan drain plug and gasket, and drain the engine oil into a container.
Install a new gasket and the oil pan drain plug.
- Torque:
- 40 N*m{ 408 kgf*cm , 30 ft.*lbf }
Install the No. 2 engine under cover seal with the 2 bolts.
- Torque:
- 10 N*m{ 102 kgf*cm , 7 ft.*lbf }
| 6. DISCONNECT OIL COOLER TUBE |
Remove the 2 bolts and disconnect the oil cooler tube.

| 7. REMOVE ENGINE OIL LEVEL SENSOR |
Disconnect the oil level sensor connector.
Remove the 4 bolts and oil level sensor.

Cut away part of the gasket and remove the gasket from the engine oil level sensor.

Text in Illustration *1
Cutting Position
*2
Supply Part
- HINT:
- Remove the only the outer part of the gasket.
