2011-2013 Land Cruiser · Service Manual Power Source / Network

Gateway ECU Communication Stop Mode

Circuit diagnosis · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

DESCRIPTION

Detection Item
Symptom
Trouble Area
Gateway ECU Communication Stop Mode
  1. "CAN Gateway" is not displayed on "Bus Check".
  2. "Gateway Communication Stop Mode" in "DTC Combination Table" applies.
  1. Power source or inside network gateway ECU
  2. Network gateway ECU main wire or connector
  3. Network gateway ECU

WIRING DIAGRAM

C174518E03

INSPECTION PROCEDURE

HINT:
Operating the ignition switch, any switches or any doors triggers related ECU and sensor communication with the CAN, which causes resistance variation.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
  1. Disconnect the cable from the negative (-) battery terminal before measuring the resistances of the main wire and the branch wire.

    CAUTION:
    For vehicles with an SRS system:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    NOTICE:
    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


NEXT


2. CHECK FOR OPEN IN CAN BUS WIRE (NETWORK GATEWAY ECU BRANCH WIRE)
C136761E06
  1. Disconnect the E31 network gateway ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    E31-16 (CA1H) - E31-15 (CA1L)
    Ignition switch off
    54 to 69 Ω



NG
REPAIR OR REPLACE NETWORK GATEWAY ECU BRANCH WIRE OR CONNECTOR (CA1H, CA1L)
OK


3. CHECK HARNESS AND CONNECTOR (NETWORK GATEWAY ECU - BATTERY AND BODY GROUND)
  1. Connect the cable to the negative (-) battery terminal.

    NOTICE:
    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  1. C136761E07
    Disconnect the E31 network gateway ECU connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    E31-4 (GND) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    E31-2 (BATT) - Body ground
    Always
    11 to 14 V
    E31-10 (IG1) - Body ground
    Ignition switch ON
    11 to 14 V
    E31-9 (IG2) - Body ground
    Ignition switch ON
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE NETWORK GATEWAY ECU (Click here)


← Air Conditioning Amplifier Communication Stop Mode (from Jan 2012)Gateway ECU Communication Stop Mode (from Jan 2012) →