2011-2013 Land Cruiser · Service Manual Vehicle Interior

INSPECTION

Inspection · Vehicles built from Sep 2011


INSPECT LIGHT CONTROL RHEOSTAT

  1. Inspect the light control rheostat.

    1. Measure the resistance according to the value(s) in the table below.

      E154786E02

      Standard Resistance:
      Tester Connection
      Switch Condition
      Specified Condition
      6 (TC) - 1 (E)
      TAIL cancel switch off → on
      10 kΩ or higher → Below 1 Ω
      5 (T) - 1 (E)
      Always
      10 kΩ or higher
      7 (TR) - 1 (E)
      Light control rheostat fully turned right → fully turned left
      10 kΩ or higher → Below 100 Ω

  1. Inspect the trip switch.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Switch Condition
      Specified Condition
      4 (A/B) - 1 (E)
      Trip switch on (Pushed)
      Below 200 Ω
      Trip switch off (Not Pushed)
      1 MΩ or higher

      If the result is not as specified, replace the rheostat.

← REMOVAL (from Jan 2012)INSTALLATION (Sep 2011 – Dec 2011) →