2011-2013 Land Cruiser · Service Manual Vehicle Interior

DISASSEMBLY

Removal / installation · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012

HINT:
  1. Use the same procedure for RHD and LHD vehicles.
  2. The procedure listed below is for LHD vehicles.


1. REMOVE CENTER HEATER TO REGISTER DUCT

  1. B180538
    Remove the 3 screws and center heater to register duct.


2. REMOVE REAR NO. 1 AIR DUCT (w/ Rear Air Duct)

  1. B180539
    Remove the 2 screws and rear No. 1 air duct.


3. REMOVE FRONT PASSENGER AIRBAG ASSEMBLY

  1. B183434
    Detach the claw and remove the wire.

  1. Disconnect the 2 connectors and remove the instrument panel wire from the front passenger airbag.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. B189610E01
    Remove the 2 screws.

  1. B189611E01
    Detach the 5 hooks (A).

  1. Detach the 5 hooks (B) and remove the front passenger airbag from the instrument panel.


4. REMOVE DEFROSTER NOZZLE ASSEMBLY

  1. B180544
    Detach the 11 claws and remove the defroster nozzle.


5. REMOVE NO. 1 SIDE DEFROSTER NOZZLE

  1. B180541
    Detach the 2 claws and remove the No. 1 side defroster nozzle.


6. REMOVE NO. 2 SIDE DEFROSTER NOZZLE

  1. B180543
    Detach the 3 claws and remove the No. 2 side defroster nozzle.


7. REMOVE NAVIGATION ANTENNA ASSEMBLY (w/ Multi-display)

B190852
  1. Detach the 2 clamps.

  1. Remove the 2 screws and antenna.


8. REMOVE ANTENNA CORD SUB-ASSEMBLY (w/ Multi-display)

  1. for LHD:
    Detach the 8 clamps and remove the antenna cord.

    B181729

  1. for RHD:
    Detach the 6 clamps and remove the antenna cord.

    B181731


9. REMOVE ANTENNA CORD SUB-ASSEMBLY (w/o Multi-display)

  1. for LHD:
    Detach the 7 clamps and remove the antenna cord.

    B181730

  1. for RHD:
    Detach the 5 clamps and remove the antenna cord.

    B181732


10. REMOVE NO. 2 INSTRUMENT PANEL WIRE (for LHD)

  1. Detach the clamps and remove the No. 2 instrument panel wire from the instrument panel.

    B180536


11. REMOVE NO. 2 INSTRUMENT PANEL WIRE (for RHD)

  1. Detach the clamps and remove the No. 2 instrument panel wire from the instrument panel.

    B190100

← REMOVAL (from Jan 2012)DISASSEMBLY (from Jan 2012) →