2011-2013 Land Cruiser · Service Manual Steering

REASSEMBLY

Removal / installation · Vehicles built from Sep 2011


1. INSTALL STEERING RACK END SUB-ASSEMBLY
  1. Temporarily install the 2 steering rack ends to the power steering rack.

  1. Fill up the ball joint of the steering rack ends with MP grease.

  1. C179178E01
    Using SST, install the power steering rack end (RH side) to the power steering rack.
    SST
    09922-10010  

    Torque:
    without SST:
    147 N*m{ 1499 kgf*cm , 108 ft.*lbf }
    with SST:
    110 N*m{ 1122 kgf*cm , 81 ft.*lbf }

    HINT:
    1. Rotate SST in the direction shown in the illustration.
    2. Use a torque wrench with a fulcrum length of 380 mm (14.97 in.).

  1. Using SST and a wrench, install the power steering rack end (LH side) to the power steering rack.

    SST
    09922-10010  

    Torque:
    without SST:
    147 N*m{ 1499 kgf*cm , 108 ft.*lbf }
    with SST:
    110 N*m{ 1122 kgf*cm , 81 ft.*lbf }

    HINT:
    1. Rotate SST in the direction shown in the illustration.
    2. Use a torque wrench with a fulcrum length of 380 mm (14.97 in.).


2. INSTALL NO. 1 STEERING RACK BOOT

C100988
  1. Apply silicon grease to the inside of the small opening of the boot.

  1. Install the 2 boots to the groove on the rack housing.


3. INSTALL STEERING RACK BOOT CLAMP RH

C124255E02
  1. Using SST, install a new boot clamp as shown in the illustration.

    SST
    09521-24010  

    Standard clearance:
    3.0 mm (0.119 in.) or less

    NOTICE:
    Be careful not to damage the boot.


4. INSTALL STEERING RACK BOOT CLAMP LH

HINT:
Use the same procedures described for the RH side.


5. INSTALL STEERING RACK BOOT CLIP RH

C178954E01
  1. Using pliers, install the boot clip.

    NOTICE:
    Make sure that the claws of each clip are positioned within the area shown in the illustration.


6. INSTALL STEERING RACK BOOT CLIP LH

HINT:
Use the same procedures described for the RH side.

← INSPECTION (from Sep 2011)INSTALLATION (Sep 2011 – Dec 2011) →