DISASSEMBLY
Removal / installation · Vehicles built from Sep 2011
- NOTICE:
- Do not disconnect the hoses indicated in the illustration.
-


| 1. REMOVE FUEL SENDER GAUGE ASSEMBLY |
Disconnect the fuel sender gauge connector.

Press down on the sender gauge claw labeled A. Then slide the sender gauge upward to remove it.

| 2. REMOVE NO. 1 FUEL SUB-TANK (for Single Tank Type) |
Using a screwdriver, detach the 3 claws from the claw holes to remove the fuel sub-tank.

- NOTICE:
- Do not damage the fuel sub-tank.
- HINT:
- Tape the screwdriver tip before use.
| 3. REMOVE NO. 1 FUEL SUB-TANK (for Double Tank Type) |
Disconnect the fuel pump connector.

Using a small screwdriver, detach the claw from the sub-tank.

- HINT:
- Tape the screwdriver tip before use.
Using a screwdriver, detach the 3 claws from the claw holes to remove the fuel sub-tank.

- NOTICE:
- Do not damage the fuel sub-tank.
- HINT:
- Tape the screwdriver tip before use.
| 4. REMOVE FUEL PUMP (for Double Tank Type) |
Using a screwdriver, detach the 2 claws from the claw holes and remove the fuel pump.

- HINT:
- Tape the screwdriver tip before use.
Disconnect the fuel pump wire harness connector from the fuel pump.

Remove the O-ring and spacer from the fuel pump.

