2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

REASSEMBLY

Removal / installation · Vehicles built from Jan 2012


NOTICE:
Do not disconnect the hoses indicated in the illustration.
A181496E02

Text in Illustration 
*a
for Single Tank Type
*b
for Double Tank Type

1. INSTALL NO. 1 FUEL SUCTION SUPPORT
  1. Attach the 2 claws to the claw holes to install the fuel suction support.


2. INSTALL FUEL MAIN VALVE ASSEMBLY

  1. A097616E18
    Apply a light coat of gasoline to 2 new O-rings, and install them onto the fuel main valve.
    Text in Illustration 
    *1
    New O-Ring

  1. A175044E02
    Install the fuel main valve to the fuel filter case.
    Text in Illustration 
    *1
    Fuel Filter Case
    *2
    O-Ring

    NOTICE:
    Make sure the O-rings are not cut or pinched during the installation.


3. INSTALL FUEL PUMP

  1. A175042
    Connect the fuel pump wire harness connector to the fuel pump.

  1. A175046E02
    Apply a light coat of gasoline to a new O-ring. Then install the O-ring and spacer to the fuel pump.
    Text in Illustration 
    *1
    O-Ring
    *2
    Spacer

  1. Attach the 5 claws to the claw holes and install the fuel pump to the fuel filter case.


4. INSTALL NO. 1 FUEL SUB-TANK (for Single Tank Type)

NOTICE:
A184234E02
Make sure that the fuel tube passes into the section marked by the circle.

Text in Illustration 
*1
Fuel Tube
  1. Attach the 3 claws to the claw holes to install the No. 1 fuel sub-tank.

  1. Attach the 3 claws to the claw holes.

  1. Install the tube part to the No. 1 fuel sub-tank.

    1. Attach the claw on the end of the tube to the claw hole. Install the tube to the 2 clamps on the No. 1 fuel sub-tank.

  1. Connect the jet pump to the No. 1 fuel sub-tank.

  1. Connect the fuel pump connector.


5. INSTALL NO. 1 FUEL SUB-TANK (for Double Tank Type)

A184234E02

NOTICE:
Make sure that the fuel tube passes into the section marked by the circle.

Text in Illustration 
*1
Fuel Tube
  1. Attach the 3 claws to the claw holes and install the No. 1 fuel sub-tank.

  1. Attach the 3 claws to the claw holes.

  1. A176343E03
    Connect the jet pump (labeled B) to the No. 1 fuel sub-tank.
    Text in Illustration 
    *1
    Jet Pump

    1. Attach the claw on the end of the tube to the claw hole.

  1. Connect the jet pump (labeled A) to the No. 1 fuel sub-tank.

  1. Connect the fuel pump connector.


6. INSTALL FUEL SENDER GAUGE ASSEMBLY

  1. A175048
    Set the sender gauge to the fuel sub-tank. Then slide the sender gauge downward to install it.
    Text in Illustration 
    V100135
    Slide

  1. Connect the fuel sender gauge connector.

← INSPECTION (from Jan 2012)INSTALLATION (from Jan 2012) →