2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

INSTALLATION

Removal / installation · Vehicles built from Jan 2012


1. INSTALL FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY
  1. Apply a light coat of gasoline or grease to a new gasket, and install it to the fuel tank.

  1. A176324E02
    Install the fuel suction with pump and gauge tube into the fuel tank.
    Text in Illustration 
    *1
    Protrusion
    *2
    Groove
    V100135
    Front

    NOTICE:
    Be careful not to bend the arm of the fuel sender gauge.

    HINT:
    Align the protrusion of the fuel suction with pump and gauge tube with the groove of the fuel tank.

  1. Put the retainer on the fuel tank. While holding the fuel suction with pump and gauge tube, tighten the retainer 1 complete turn by hand.

  1. A242908E01
    Set SST on the retainer.
    SST
    09808-14030  

    HINT:
    1. Hold the fuel suction tube assembly upright by hand to make sure that the fuel suction tube gasket is not moved out of position.
    2. Engage the claws of SST securely with the fuel pump gauge retainer holes to secure SST.
    3. Install SST while pressing the claws of SST against the fuel pump gauge retainer (toward the center of SST).

  1. A242906E03
    Using SST, tighten the retainer until the mark on the retainer is within range A on the fuel tank as shown in the illustration.
    SST
    09808-14030  
    Text in Illustration 
    *1
    Fuel Tank Side Mark
    *2
    Retainer Side Mark

    HINT:
    Fit the tips of SST onto the ribs of the retainer.


2. INSTALL FUEL TANK SUB-ASSEMBLY
(Click here)
← REASSEMBLY (from Jan 2012)COMPONENTS (from Jan 2012) →