2011-2013 Land Cruiser · Service Manual Suspension

REMOVAL

Removal / installation · Vehicles built from Sep 2011

HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.


1. REMOVE SIDE STEP ASSEMBLY LH

  1. Remove the 6 bolts and side step.

    B180949


2. REMOVE HEIGHT CONTROL PROTECTOR PIPE

  1. Remove the 6 bolts and protector pipe.

    C179788E01


3. REMOVE HEIGHT CONTROL CYLINDER BRACKET ASSEMBLY

  1. Remove the 6 bolts and 3 brackets from the frame.

    C179787


4. DISCHARGE SUSPENSION FLUID PRESSURE

  1. C172939
    Connect a hose to the bleeder plug for the shock absorber control valve and loosen the bleeder plug.

  1. Discharge the suspension fluid pressure.

  1. After the fluid pressure has dropped and oil has drained out, tighten the bleeder plug and remove the hose.

    Torque:
    8.3 N*m{ 85 kgf*cm , 73 in.*lbf }


5. REMOVE NO. 1 HEIGHT CONTROL TUBE LH

  1. C172812E01
    Remove the union bolt and gasket from the front No. 1 accumulator.

  1. C175210
    Using a union nut wrench, remove the No. 1 control tube from the shock absorber control valve.


6. REMOVE FRONT NO. 1 SUSPENSION CONTROL ACCUMULATOR ASSEMBLY LH

C172813
  1. Remove the 2 bolts and No. 1 suspension control accumulator from the vehicle.


7. REMOVE FRONT NO. 2 SUSPENSION CONTROL ACCUMULATOR LH

  1. C172807
    Remove the No. 2 control accumulator and O-ring from the front shock absorber control valve.


8. REMOVE NO. 2 HEIGHT CONTROL TUBE LH
  1. Using a union nut wrench, disconnect the No. 2 control tube from the No. 3 height control tube, shock absorber control valve and control valve.

  1. Remove the bolt and No. 2 control tube.

    C172809E01


9. DISCONNECT NO. 2 SUSPENSION CONTROL PRESSURE HOSE

  1. C175215E01
    Remove the union bolt and gasket, then disconnect the No. 2 pressure hose from the shock absorber control valve.


10. REMOVE FRONT SHOCK ABSORBER CONTROL VALVE ASSEMBLY LH

  1. C172811
    Disconnect the connector.

  1. C172616
    Remove the 3 bolts and control valve.

  1. Remove the cap and bleeder plug.


11. REMOVE FRONT NO. 3 SUSPENSION CONTROL ACCUMULATOR LH

  1. C176190
    Remove the control accumulator from the control valve.

  1. Remove the O-ring and back-up ring from the accumulator.


12. REMOVE FRONT SUSPENSION CONTROL VALVE ASSEMBLY LH

  1. C172805
    Disconnect the connector from the control valve.

  1. C172615
    Remove the 3 bolts and control valve.

← ON-VEHICLE INSPECTION (from Sep 2011)INSPECTION (from Sep 2011) →