2011-2013 Land Cruiser · Service Manual Vehicle Interior

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Sep 2011


CHECK MAP LIGHT ASSEMBLY

  1. E155947E01
    Remove the map light with the connector connected.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    R7-6 (RILL) - R7-17 (GND9)
    Rear dome light off
    11 to 14 V
    Rear dome light on
    Below 1 V
    R7-10 (ILL-) - R7-17 (GND9)
    Headlight dimmer switch off
    11 to 14 V
    Headlight dimmer switch on
    Below 1 V
    R7-13 (ILL+) - R7-17 (GND9)
    Engine switch on (ACC)
    11 to 14 V
    R7-15 (+B) - R7-17 (GND9)
    Always
    11 to 14 V
    R7-16 (DOME) - R7-17 (GND9)
    Always
    11 to 14 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    R7-1 (GND6) - Body ground
    Always
    Below 1 Ω
    R7-17 (GND9) - Body ground
    Always
    Below 1 Ω

    If the result is not as specified, replace the map light assembly.

← COMPONENTS (from Sep 2011)REMOVAL (from Sep 2011) →