2011-2013 Land Cruiser · Service Manual Suspension

INSTALLATION

Removal / installation · Vehicles built from Sep 2011

HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.
  3. A bolt without a torque specification is shown in the standard bolt chart (Click here).


1. INSTALL FRONT HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH

  1. C172821
    Install the sensor with the bolt and nut.

    Torque:
    for bolt:
    13 N*m{ 127 kgf*cm , 9 ft.*lbf }
    for nut:
    5.6 N*m{ 57 kgf*cm , 50 in.*lbf }

  1. Connect the connector.


2. INSTALL FRONT WHEEL

Torque:
for Aluminum Wheel:
131 N*m{ 1336 kgf*cm , 97 ft.*lbf }
for Steel Wheel:
209 N*m{ 2131 kgf*cm , 154 ft.*lbf }


3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


4. PERFORM VEHICLE HEIGHT OFFSET CALIBRATION
  1. Perform the vehicle height offset calibration (Click here).


5. ADJUST FRONT HEIGHT CONTROL SENSOR LINK SUB-ASSEMBLY

NOTICE:
  1. Make adjustments from the link that deviates the most from the specified vehicle height value.
  2. When the front and rear are at the same level, make adjustments from the front first.
  3. If adjustment cannot be completed through the vehicle height offset calibration, adjust the sensor link using the following procedure.

  1. C176320
    Loosen the nut and adjust the link installation position by moving the height control sensor link up or down in the long hole of the bracket.

    HINT:
    When the link is moved 1 mm (0.0394 in.), the vehicle height changes by approximately 2 mm (0.0787 in.).

  1. Tighten the nut of the height control sensor link.

    Torque:
    5.6 N*m{ 57 kgf*cm , 50 in.*lbf }


6. INSTALL FRONT FENDER APRON SEAL LH

  1. C173474
    Install the apron seal with the 4 clips.


7. PERFORM ZERO POINT CALIBRATION OF G SENSOR
  1. Perform the zero point calibration of G sensor (Click here).


8. ADJUST HEADLIGHT ASSEMBLY
  1. for Standard:
    Adjust the headlight (Click here).

  1. for HID Headlight:
    Adjust the headlight (Click here).

← ADJUSTMENT (from Sep 2011)COMPONENTS (from Sep 2011) →