2011-2013 Land Cruiser · Service Manual Suspension

INSPECTION

Inspection · Vehicles built from Sep 2011


INSPECT FRONT HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH

C172945E03

NOTICE:
Do not drop the height control sensor. If it is dropped, replace it with a new one.

  1. Connect 3 dry batteries of 1.5 V in series.

  1. Connect the positive (+) end of the batteries to terminal 3 (SHB) of the height control sensor and the negative (-) end of the batteries to terminal 1 (SHG). While slowly moving the sensor link up and down, measure the voltage between terminal 2 (SHFR*1, SHFL*2) and terminal 1 (SHG).

    HINT:
    *1: for RH
    *2: for LH


    1. Measure the voltage according to the value(s) in the table below.

      Standard Voltage:
      for RH 
      Tester Connection
      Condition
      Specified Condition
      2 (SHFR) - 1 (SHG)
      Max. HI
      Approx. 4.1 V
      Normal
      Approx. 2.25 V
      Min. LO
      Approx. 0.45 V
      for LH 
      Tester Connection
      Condition
      Specified Condition
      2 (SHFL) - 1 (SHG)
      Max. HI
      Approx. 4.1 V
      Normal
      Approx. 2.25 V
      Min. LO
      Approx. 0.45 V

      NOTICE:
      Do not apply a voltage of higher than 6 V.

      If the result is not as specified, replace the front height control sensor.

← REMOVAL (from Sep 2011)ADJUSTMENT (from Sep 2011) →