2011-2013 Land Cruiser · Service Manual Suspension

REMOVAL

Removal / installation · Vehicles built from Sep 2011

HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


2. REMOVE FRONT WHEEL

3. REMOVE FRONT FENDER APRON SEAL LH

  1. C173474
    Using a clip remover, remove the 4 clips and apron seal.


4. REMOVE FRONT HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH

  1. C172821
    Disconnect the connector.

  1. Remove the nut, bolt and sensor.

← COMPONENTS (from Sep 2011)INSPECTION (from Sep 2011) →