2011-2013 Land Cruiser · Service Manual Suspension

INSTALLATION

Removal / installation · Vehicles built from Sep 2011


1. INSTALL SUSPENSION CONTROL ECU

  1. C172944
    Attach the wire harness clamp and connect the connector.

  1. Install the ECU with the 2 bolts.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }


2. INSTALL REAR SIDE NO. 2 AIR DUCT (w/ Heater)

E154788
  1. Install the duct with the 3 screws.

    Torque:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }


3. INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY LH

B188391
  1. Attach the 6 clips to install the quarter trim cover.


4. INSTALL REAR SEAT COVER CAP (w/ Rear No. 2 Seat, except Face to Face Seat Type)

B190214

HINT:
Use the same procedure to install the rear seat cover cap on the other side.

  1. Attach the 3 claws to install the rear seat cover cap.


5. INSTALL NO. 1 TONNEAU COVER HOLDER CAP (w/ Tonneau Cover)

B186439

HINT:
Use the same procedure to install the tonneau cover holder cap on the other side.

  1. Attach the 2 claws to install the tonneau cover holder cap.


6. INSTALL REAR FLOOR MAT REAR SUPPORT PLATE

B181672
  1. Attach the 6 clips to install the support plate.


7. INSTALL REAR DOOR SCUFF PLATE LH

B181674
  1. Attach the 3 claws and 4 clips to install the scuff plate.

  1. Install the screw.


8. INSTALL REAR STEP COVER

B181673

HINT:
Use the same procedure to install the step cover on the other side.

  1. Attach the 2 claws to install the step cover.


9. INSTALL REAR NO. 2 SEAT ASSEMBLY LH (except Face to Face Seat Type)
  1. Install the rear No. 2 seat assembly LH (Click here).


10. INSTALL REAR NO. 2 SEAT ASSEMBLY RH (except Face to Face Seat Type)

HINT:
Use the same procedures described for the LH side.


11. INSTALL REAR NO. 2 SEAT ASSEMBLY LH (for Face to Face Seat Type)
  1. Install the rear No. 2 seat assembly LH (Click here).


12. INSTALL REAR NO. 2 SEAT ASSEMBLY RH (for Face to Face Seat Type)

HINT:
Use the same procedures described for the LH side.


13. INSTALL TONNEAU COVER ASSEMBLY (w/ Tonneau Cover)
  1. Install the tonneau cover assembly.


14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


15. PERFORM VEHICLE HEIGHT OFFSET CALIBRATION
  1. Perform the vehicle height offset calibration (Click here).


16. PERFORM ZERO POINT CALIBRATION OF G SENSOR
  1. Perform the zero point calibration of G sensor (Click here).


17. ADJUST HEADLIGHT ASSEMBLY
  1. for Standard:
    Adjust the headlight (Click here).

  1. for HID Headlight:
    Adjust the headlight (Click here).

← REMOVAL (from Sep 2011)COMPONENTS (from Sep 2011) →