2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

REMOVAL

Removal / installation · Vehicles built Sep 2011 – Dec 2011

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  1. Disconnect the cables from the negative (-) main battery and sub-battery terminals.


2. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH
  1. Remove the 3 bolts and screw.

  1. Loosen the clip and remove the splash shield.


3. REMOVE FRONT FENDER LINER RH
  1. Remove the screw and disconnect the liner from the front bumper cover.

  1. Using a T30 "TORX" socket, remove the 3 screws.

  1. Remove the 5 clips.

    HINT:
    It is not necessary to fully remove the fender liner. Partially remove it so that the air pump can be removed.


4. REMOVE TURBO MOTOR DRIVER

  1. A174829E01
    Disconnect the connector.

    1. Disconnect the connector as follows: (1) push the claw upward, and (2) move the lock lever to release the lock.

  1. A174830
    Remove 2 nuts, bolt and turbo motor driver.

  1. A181672
    Disconnect the 4 connectors from the turbo motor driver.

  1. Remove the 8 screws and 2 turbo motor drivers from the brackets.

← COMPONENTS (from Jan 2012)REMOVAL (from Jan 2012) →