2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

REMOVAL

Removal / installation · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).


2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable some systems need to be initialized after the cable is reconnected (Click here).


3. REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH
  1. Remove the 3 bolts and 2 screws.

  1. Loosen the clip and remove the front fender splash shield RH.


4. REMOVE FRONT FENDER LINER RH
  1. Remove the screw and disconnect the liner from the front bumper cover.

  1. Using a T30 "TORX" socket, remove the 3 screws.

  1. Remove the 5 clips.

    HINT:
    It is not necessary to fully remove the fender liner. Partially remove it so that the air pump can be removed.


5. REMOVE TURBO MOTOR DRIVER

  1. A174829E01
    Disconnect the connector.

    1. Disconnect the connector as follows: (1) push the claw upward, and (2) move the lock lever to release the lock.

  1. A174830
    Remove 2 nuts, bolt and turbo motor driver.

← REMOVAL (Sep 2011 – Dec 2011)INSTALLATION (Sep 2011 – Dec 2011) →