2011-2013 Land Cruiser · Service Manual Vehicle Exterior

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Sep 2011


REMOVE DEFOGGER RELAY (DEFOG)

B106753E01
  1. Remove the defogger relay from the engine room junction block.


INSPECT DEFOGGER RELAY
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 4
    Battery voltage is not applied to terminals 1 and 2
    Below 1 Ω
    3 - 5
    10 kΩ or higher
    3 - 4
    Battery voltage is applied to terminals 1 and 2
    10 kΩ or higher
    3 - 5
    Below 1 Ω

    If the result is not as specified, replace the relay.


INSTALL DEFOGGER RELAY
  1. Install the defogger relay to the engine room junction block.

← ON-VEHICLE INSPECTION (from Sep 2011)PARTS LOCATION (from Sep 2011) →