SYSTEM DIAGRAM
System information · Vehicles built Sep 2011 – Dec 2011
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
| w/ Network Gateway ECU |


| No. |
ECU/Sensor Name |
| 1 |
ECM |
| 2 |
Network Gateway ECU |
| 3 |
Main Body ECU (Cowl Side Junction Block LH) |
| 4 |
DLC3 |
| 5 |
Air Conditioning Amplifier |
| 6 |
Center Airbag Sensor*11 |
| 7 |
Multi-display*1 |
| 8 |
Combination Meter |
| 9 |
Certification ECU (Smart Key ECU)*10 |
| 10 |
Multiplex Tilt and Telescopic ECU*2 |
| 11 |
Outer Mirror Control ECU*3 |
| 12 |
Windshield Wiper ECU*4 |
| 13 |
Position Control ECU and Switch*3 |
| 14 |
Accessory Bus Buffer |
| 15 |
Master Cylinder Solenoid (Skid Control ECU) |
| 16 |
Yaw Rate Sensor |
| 17 |
Steering Control ECU*5 |
| 18 |
Steering Angle Sensor |
| 19 |
4WD Control ECU |
| 20 |
|
| 21 |
Seat Belt Control ECU*8 |
| 22 |
Suspension Control ECU*9 |
| 23 |
No. 1 CAN Junction Connector |
- HINT:
- *1: w/ Navigation System
- *2: w/ Power Tilt and Power Telescopic Steering Column System
- *3: w/ Seat Memory
- *4: w/ Rain Sensor
- *5: w/ Variable Gear Ratio Steering System
- *6: w/ Parking Assist Monitor System
- *7: w/ TOYOTA Parking Assist-sensor System
- *8: w/ Pre-Crash Safety System
- *9: w/ Active Height Control Suspension
- *10: w/ Entry and Start System
- *11: w/ Airbag System






- HINT:
- The master cylinder solenoid (skid control ECU) stores steering sensor and yaw rate sensor DTCs and performs DTC communication by receiving information from the steering sensor and yaw rate sensor.
- The ECM uses the CAN communication system to perform DTC communication instead of the conventional communication line (SIL).
- The master cylinder solenoid (skid control ECU) stores steering sensor and yaw rate sensor DTCs and performs DTC communication by receiving information from the steering sensor and yaw rate sensor.
| w/o Network Gateway ECU |


| No. |
ECU/Sensor Name |
| 1 |
ECM |
| 2 |
Combination Meter |
| 3 |
Main Body ECU (Cowl Side Junction Block LH) |
| 4 |
DLC3 |
| 5 |
Air Conditioning Amplifier |
| 6 |
Center Airbag Sensor*5 |
| 7 |
Display and Navigation Module Display*1 |
| 8 |
4WD Control ECU |
| 9 |
Clearance Warning ECU*2 |
| 10 |
Master Cylinder Solenoid (Skid Control ECU) |
| 11 |
Certification ECU (Smart Key ECU)*4 |
| 12 |
Multiplex Tilt and Telescopic ECU*3 |
| 13 |
Accessory Bus Buffer |
- HINT:
- *1: w/ Navigation System
- *2: w/ TOYOTA Parking Assist-sensor System
- *3: w/ Power Tilt and Power Telescopic Steering Column System
- *4: w/ Entry and Start System
- *5: w/ Airbag System




- HINT:
- The ECM uses the CAN communication system to perform DTC communication instead of the conventional communication line (SIL).