REASSEMBLY
Removal / installation · Vehicles built from Sep 2011
| 1. INSTALL STABILIZER CONTROL ADAPTER SHUTTER VALVE (for Lower Chamber Side) |
![]() ![]() |
Apply a small amount of suspension fluid to a new O-ring and install it to the shutter valve.
Install the shutter valve to the adapter housing.
- Torque:
- 14 N*m{ 143 kgf*cm , 10 ft.*lbf }
| 2. INSTALL STABILIZER CONTROL ADAPTER SHUTTER VALVE (for Upper Chamber Side) |
- HINT:
- Use the same procedures described for the lower chamber side.
| 3. INSTALL OIL NOZZLE VALVE SUB-ASSEMBLY (for Lower Chamber Side) |
Before installing the oil nozzle valve, apply suspension fluid to the oil nozzle valve O-ring.
Install the oil nozzle valve to the adapter housing.

- Torque:
- 12 N*m{ 122 kgf*cm , 9 ft.*lbf }
| 4. INSTALL OIL NOZZLE VALVE SUB-ASSEMBLY (for Upper Chamber Side) |
- HINT:
- Use the same procedures described for the lower chamber side.
| 5. INSTALL SERVICE VALVE CAP (for Lower Chamber Side) |
![]() ![]() |
Install the valve cap to the oil nozzle valve.
- Torque:
- 0.6 N*m{ 6.0 kgf*cm , 5.0 in.*lbf }
| 6. INSTALL SERVICE VALVE CAP (for Upper Chamber Side) |
- HINT:
- Use the same procedures described for the lower chamber side.


