Bleed the air from the suspension fluid (Click here).
13.
INSPECT FOR SUSPENSION FLUID LEAK
CAUTION:
Fluid is pumped into the system at a high pressure of approximately 3 MPa (30.6 kgf/cm2, 435 psi). If a fluid leak is discovered, immediately release the pressure and repair the fluid leak.
Perform a driving test.
Check for fluid leakage from the parts and connections.
14.
INSPECT FOR EXHAUST GAS LEAK
If gas is leaking, tighten the areas necessary to stop the leak. Replace damaged parts as necessary.
15.
MEASURE VEHICLE HEIGHT
NOTICE:
Perform the inspection on a level surface.
Ensure that the wheels are on the ground and facing straight ahead.
Perform the inspection with the vehicle load completely on the suspension.
HINT:
Perform this step with the fuel tank full.
If there are any parts installed to the vehicle which place any unbalanced load on the left or right side of the vehicle, remove them.
Set the tire pressure to the specified value(s) (Click here).
Bounce the vehicle to stabilize the suspension.
Measure the distance from the ground to the top of the bumper and calculate the difference in the vehicle height between left and right. Perform this procedure for both the front and rear wheels.
Height difference of left and right sides:
15 mm (0.591 in.) or less
HINT:
If not as specified, perform the vehicle tilt calibration.
16.
CLOSE STABILIZER CONTROL WITH ACCUMULATOR HOUSING SHUTTER VALVE
NOTICE:
Perform the inspection on a level surface.
Ensure that the wheels are on the ground and facing straight ahead.
Perform the inspection with the vehicle load completely on the suspension.
HINT:
Perform this step with the fuel tank full.
If there are any parts installed to the vehicle which place any unbalanced load on the left or right side of the vehicle, remove them.
Using a 5 mm hexagon socket wrench, tighten the lower and upper chamber shutter valves of the stabilizer control with accumulator housing.
Torque:
14 N*m{
143 kgf*cm
, 10 ft.*lbf
}
17.
INSTALL STABILIZER CONTROL VALVE PROTECTOR
Install the valve protector with the 3 bolts.
Torque:
18 N*m{
184 kgf*cm
, 13 ft.*lbf
}
Attach the clamp, and connect the connector to the valve protector.