2011-2013 Land Cruiser · Service Manual Drivetrain

INSTALLATION

Removal / installation · Vehicles built from Sep 2011


1. INSTALL NO. 1 TRANSFER INDICATOR SWITCH

  1. Using a SST, install a new gasket and the indicator switch.

    SST
    09922-10010  

    C179837E01

    Torque:
    without SST:
    40 N*m{ 408 kgf*cm , 30 ft.*lbf }
    with SST:
    28 N*m{ 283 kgf*cm , 20 ft.*lbf }

    NOTICE:
    1. Rotate SST in the direction shown in the illustration.
    2. Use a torque wrench with a fulcrum length of 300 mm (11.8 in.).

  1. Connect the connector.


2. INSTALL REAR DIFFERENTIAL LOCK ACTUATOR PROTECTOR

  1. C174229
    Install the protector with the 2 nuts.

    Torque:
    35 N*m{ 357 kgf*cm , 26 ft.*lbf }


3. INSTALL DIFFERENTIAL PROTECTOR ASSEMBLY

  1. C174228
    Attach the protector with the bolt and nut.

    Torque:
    15 N*m{ 150 kgf*cm , 11 ft.*lbf }

  1. Connect the 2 connector clamps and wire harness clamp.

    NOTICE:
    Make sure the wire harness of the No. 4 transfer indicator switch fits inside the protector.

← INSPECTION (from Sep 2011)PRECAUTION (from Sep 2011) →