REMOVAL
Removal / installation · Vehicles built Sep 2011 – Dec 2011
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
| 1.
REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY LH
|
 |
- Remove the 3 bolts and screw.
Loosen the clip and remove the splash shield.
| 2.
REMOVE FRONT FENDER SPLASH SHIELD SUB-ASSEMBLY RH
|
 |
Remove the 3 bolts and screw.
Loosen the clip and remove the splash shield.
| 3.
REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
|
 |
- Remove the 10 bolts and under cover.
| 4.
REMOVE UPPER RADIATOR SUPPORT SEAL
|
 |
Remove the 7 clips and upper radiator support seal.
| 5.
REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY (w/ Intercooler)
|
 |
- Remove the 2 nuts and No. 1 engine cover.
| 6.
REMOVE AIR CLEANER CAP SUB-ASSEMBLY
|
 |
- Loosen the hose clamp.
Disconnect the mass air flow meter connector and using a clip remover, detach the wire harness clamp from the air cleaner cap.
Detach the 4 clamps and remove the air cleaner cap.
| 7.
REMOVE NO. 1 AIR CLEANER HOSE
|
 |
- Loosen the hose clamp and remove the No. 1 air cleaner hose.
| 8.
REMOVE INTAKE AIR CONNECTOR
|
 |
- w/o Viscous Heater:
Disconnect the connector from the water temperature sensor.
Using a clip remover, detach the 3 wire harness clamps.
w/ Viscous Heater:
Disconnect the 2 connectors from the viscous with magnet clutch heater and water temperature sensor.
Using a clip remover, detach the 3 wire harness clamps.
- Loosen the 2 hose clamps and remove the 2 bolts and intake air connector.
| 9.
REMOVE V-RIBBED BELT (w/ Viscous Heater) |
 |
- Loosen the lock nut and turn the bolt counterclockwise.
Remove the V-ribbed belt.
| 10.
REMOVE NO. 1 IDLER PULLEY (w/ Viscous Heater) |
 |
- Remove the bolt, cover, No. 1 idler pulley and collar.
| 11.
REMOVE NO. 3 IDLER PULLEY (w/ Viscous Heater) |
 |
- Remove the nut and No. 3 idler pulley.
| 12.
REMOVE V-RIBBED BELT |
 |
- Using a wrench to the V-ribbed belt tensioner bracket, turn the wrench clockwise and remove the V-ribbed belt.