REMOVAL
Removal / installation · Vehicles built Sep 2011 – Dec 2011
Versions by build date: Sep 2011 – Dec 2011 from Jan 2012
| 1.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
|
| 2.
REMOVE NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION
|
 |
- Place protective tape as shown in the illustration.
Using a moulding remover, detach the 7 claws and remove the panel cushion.
| 3.
REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH
|
 |
- Remove the clip.
Remove the screw.
Detach the 8 claws.
Remove the panel pad and disconnect the connectors and 2 clamps.
| 4.
REMOVE NO. 1 INSTRUMENT PANEL FINISH PANEL CUSHION
|
 |
- Place protective tape as shown in the illustration.
Using a moulding remover, detach the 7 claws and remove the panel cushion.
| 5.
REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH
|
 |
- Remove the clip.
Remove the screw.
Detach the 7 claws and remove the panel.
| 6.
REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY
|
 |
Twist the shift lever knob in the direction indicated by the arrow and remove it.


| 7.
REMOVE LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY
|
 |
- Detach the 7 claws.
Disconnect the connectors and remove the panel.
| 8.
REMOVE REAR UPPER CONSOLE PANEL SUB-ASSEMBLY
|
 |
- Detach the 9 claws and remove the panel.
| 9.
REMOVE CONSOLE CUP HOLDER BOX SUB-ASSEMBLY
|
 |
- Detach the 4 claws and remove the box.
| 10.
REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY
|
 |
- Detach the 14 claws.
Disconnect the connectors and remove the console panel.
| 11.
REMOVE NO. 1 STEREO JACK ADAPTER ASSEMBLY |
 |
- Detach the 2 claws and remove the stereo jack adapter.
| 12.
REMOVE REAR CONSOLE END PANEL SUB-ASSEMBLY
|
 |
- Place protective tape as shown in the illustration.
Using a moulding remover, detach the 8 claws.
Remove the end panel and disconnect the connectors and 2 clamps.
| 13.
REMOVE HEADPHONE TERMINAL |
 |
- Remove the 2 screws.
Detach the connector clamp.
- Detach the 4 claws and remove the terminal.