2011-2013 Land Cruiser · Service Manual Audio / Visual / Telematics

REMOVAL

Removal / installation · Vehicles built from Jan 2012

Versions by build date: Sep 2011 – Dec 2011 from Jan 2012


1. PRECAUTION

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).


2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).


3. REMOVE NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION

  1. E155426E02
    Place protective tape as shown in the illustration.

  1. Using a moulding remover, detach the 7 claws and remove the panel cushion.


4. REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY LH

  1. B181910
    Remove the clip.

  1. Remove the screw.

  1. Detach the 8 claws.

  1. Remove the panel pad and disconnect the connectors and 2 clamps.


5. REMOVE NO. 1 INSTRUMENT PANEL FINISH PANEL CUSHION

  1. B180004E01
    Place protective tape as shown in the illustration.

  1. Using a moulding remover, detach the 7 claws and remove the panel cushion.


6. REMOVE LOWER INSTRUMENT PANEL PAD SUB-ASSEMBLY RH

  1. B180005
    Remove the clip.

  1. Remove the screw.

  1. Detach the 7 claws and remove the panel.


7. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY

  1. Twist the shift lever knob in the direction indicated by the arrow and remove it.

    B186290E01


8. REMOVE LOWER CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

  1. B180006
    Detach the 7 claws.

  1. Disconnect the connectors and remove the panel.


9. REMOVE REAR UPPER CONSOLE PANEL SUB-ASSEMBLY

  1. B180009
    Detach the 9 claws and remove the panel.


10. REMOVE CONSOLE CUP HOLDER BOX SUB-ASSEMBLY

  1. B180010
    Detach the 4 claws and remove the box.


11. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY

  1. B180011
    Detach the 14 claws.

  1. Disconnect the connectors and remove the console panel.


12. REMOVE NO. 1 STEREO JACK ADAPTER ASSEMBLY

  1. B182275
    Detach the 2 claws and remove the stereo jack adapter.


13. REMOVE REAR CONSOLE END PANEL SUB-ASSEMBLY

  1. B180013E01
    Place protective tape as shown in the illustration.

  1. Using a moulding remover, detach the 8 claws.

  1. Remove the end panel and disconnect the connectors and 2 clamps.


14. REMOVE HEADPHONE TERMINAL

  1. B182273E01
    Remove the 2 screws.

  1. Detach the connector clamp.

  1. B182272
    Detach the 4 claws and remove the terminal.

← REMOVAL (Sep 2011 – Dec 2011)INSTALLATION (Sep 2011 – Dec 2011) →