2011-2013 Land Cruiser · Service Manual Engine / Hybrid / EV System

REMOVAL

Removal / installation · Vehicles built from Sep 2011

CAUTION:
  1. Wear protective gloves and protective glasses when removing the exhaust pipe.
  2. The exhaust pipe is extremely hot immediately after the engine has stopped.
  3. Confirm that the exhaust pipe has cooled down before removing it.


1. REMOVE FRONT FENDER APRON SEAL REAR RH

  1. A177002
    Using a clip remover, remove the 4 clips and fender apron seal.


2. REMOVE FRONT FENDER APRON SEAL REAR LH

  1. A177005
    Using a clip remover, remove the 4 clips and fender apron seal.


3. REMOVE NO. 2 ENGINE UNDER COVER

  1. C173930
    Remove the 6 bolts and under cover.


4. REMOVE TAILPIPE ASSEMBLY
  1. Remove the bolt, clamp and gasket.

  1. Disconnect the tailpipe from the 2 exhaust pipe supports.


5. REMOVE CENTER EXHAUST PIPE ASSEMBLY
  1. Remove the 4 bolts and 2 compression springs.

  1. Disconnect the center exhaust pipe from the 3 exhaust pipe supports.

  1. Remove the gasket from the front exhaust pipe.


6. REMOVE FRONT NO. 1 EXHAUST PIPE ASSEMBLY
  1. Remove the 2 nuts and front exhaust pipe.

  1. Remove the gasket.


7. REMOVE FRONT NO. 2 EXHAUST PIPE ASSEMBLY
  1. Remove the 2 nuts, 2 bolts and front exhaust pipe.

  1. Remove the gasket.


8. REMOVE MONOLITHIC CONVERTER ASSEMBLY RH (w/ Monolithic Converter)

  1. A174834
    Remove the 3 bolts and manifold stay RH.

  1. Remove the 3 nuts and monolithic converter RH.

  1. Remove the gasket from the turbocharger.


9. REMOVE MONOLITHIC CONVERTER ASSEMBLY LH (w/ Monolithic Converter)

  1. A174833
    Remove the 3 bolts and manifold stay LH.

  1. Remove the 3 nuts and monolithic converter LH.

  1. Remove the gasket from the turbocharger.


10. REMOVE OUTLET TURBINE ELBOW RH (w/o Monolithic Converter)

  1. A174836
    Remove the 3 bolts and manifold stay RH.

  1. Remove the 3 nuts and outlet turbine elbow RH.

  1. Remove the gasket from the turbocharger.


11. REMOVE OUTLET TURBINE ELBOW LH (w/o Monolithic Converter)

  1. A174835
    Remove the 3 bolts and manifold stay LH.

  1. Remove the 3 nuts and outlet turbine elbow LH.

  1. Remove the gasket from the turbocharger.

← COMPONENTS (from Jan 2012)INSTALLATION (Sep 2011 – Dec 2011) →